Tools you will need, Phillips head screw driver, ¼” Drill Bit, Level or tape measure.
Take apart the four stand-offs which are attached to the packaging.
Install stand-offs in the bottom two holes of your plaque. Make sure rubber washers are on each side.
Determine your mounting surface:
Wood surface – You will need 2 Wood Screws.
Drywall surface – You will need 2 Plastic Wall Anchors w/2 screws (Provided)
Concrete surface – You will need 2 Plastic Wall Anchors w/2 screws (Provided)
Drill the two top holes using the appropriate drill bit.
Wood surface – drill a pilot hole using proper drill bit going 1” deep.
Drywall surface – drill a pilot hole using proper drill bit going 1” deep. (Use screws provided for this procedure). After hole is drilled, place plastic wall anchor into hole
Concrete surface – drill a pilot hole using proper drill bit going 1” deep. (Use screws provided for this procedure). After hole is drilled, place plastic wall anchor into hole.
Insert the screw through Stand-Off base. Tighten the screw into the pre-drilled pilot hole or plastic insert in the wall until securely fastened.
Align the Lucinda Plaque top two holes over the stand-off bases. Screw Stand-Off caps through Lucinda plaque into Stand-Off bases and tighten by hand. No need to fix the bottom two stand-offs to wall.
Stand back and admire your plaque beautifully hung on your wall!